LX-110/120

General Purpose Solid State Recording

• Compact Flash Recording Media
• Up to 32 channels per chassis
• Up to 4 chassis for 128 channels
• 40 KHz Max Bandwidth
• 24 Bit A/D

LX-100Series data accquisition and recording system. TEAC has been desined for fast set-up,reliable recording applications in the field and in the laboratory. Building upon the success and convenience of TEAC DAT recorders, the LX-100Series enables recording of wider bandwidths,has built-in connectivity with sensors, removable solid-state digtal recording media,easy and fast PC connection,and is desigened to provide cost-efficient data recording and front-end solutions.

More: TEAC Webpage | Brochure

AQ-VU Visual Data Recorder

Sychronous video and voltage recording

• 4 channels video, 4 channels voltage
• Removal HDD media
• 2 KHz Voltage Sampling Rate

AQ-VU is a visual data recorder with 4 video input channels and 4 analog voltage input channels that can be synchronously recorded and played back. Video and data can be verified or played-back without a PC using a LCD monitor and stand-alone AQ-VU. AQ-VU is a remarkable data recorder that can visually confirm a physical event without connecting to a PC.

AQ-VU uses its HDD as a linear device (like a tape).  Any data which was recorded before interruption of power source can be reproduced.  Record duration of 5 hours available utilising exclusive 40 GB HDD pack.

More: TEAC Webpage | Brochure

es8 Field Recording Unit

Low Cost, Small

• Compact Flash Recording Media
• 8 channels
• 5 KHz Max Sampling Rate

The es8 recorder uses a Compact Flash memory card for recording. A stand-alone operation with the LCD and the key allows you to set, monitor, and record.  By connecting to a PC with a built-in USB interface, you can perform the wave monitor and the recording control.

While simultaneously sampling on all channels, using the 16 bits A/D converter individually equiped in each channel, approximately four hours of continuous recording can be done with an internal dry cell battery.  An external battery will extend recording time.

The sampling frequency ranges are 5kHz to 1/60Hz. Combining with various types of sensor amplifiers, a wide range of measurement is possible such as earthquake, natural phenomenon and stractual vibration, mechanical vibration measurement of the strain measurement, and bio-signal measurement.

More: TEAC Webpage | Brochure